|
|
Post by casias on Jan 28, 2014 21:03:32 GMT -5
I thought I would post a clear picture of the modification required to the driver's side motor perch to use with the adapter plates. The plates add 1 1/4 inch in thickness, so a notch is made to keep the motor aligned, and let it sit in the original perches. I also deepened both sides by about 1/2 inch to allow the truck manifold to fit under the shelf. Car manifolds will clear without trouble.   |
|
|
|
Post by taylor on Sept 6, 2015 13:48:35 GMT -5
I see you lowered the hole by 1/2" on both sides, how far to the d.s did you go with new hole on d.s perch?
is it 1-1/4"?
|
|
|
|
Post by casias on Sept 8, 2015 6:22:52 GMT -5
I just responded to your text. I wish I could tell you the exact dimension, but I don't remember. I sat the motor in, eyeballed it, and made a mark where to notch.
|
|
|
|
Post by casias on Jun 22, 2017 17:17:07 GMT -5
bump
2000 Durango ZL1 AWD
1999 Dakota R/T 6.0/6l90
|
|
