|
Post by ndrprssr2001 on Sept 15, 2014 17:21:07 GMT -5
Have the engine sitting in the truck. Been picking up a few bolt ons...heheh. Thanks for the mounts! Attachments:
|
|
|
Post by ndrprssr2001 on Sept 15, 2014 17:45:32 GMT -5
Hot side tacked together, headed to be tig welded. $200. In the U bends, v bands and flex pipes. Turbo is a gt45, the wastegat is an ebay Godspeed 60mm. Attachments:
|
|
|
Post by ndrprssr2001 on Sept 15, 2014 17:50:05 GMT -5
Used a small flux core welder to tack it. Looks rough. Sure it will look much better after welded. Attachments:
|
|
|
Post by casias on Sept 15, 2014 17:50:40 GMT -5
Looks good. The picture is dark. Did you have to cut farther on the driver's side perch than I did? Or is it about the same? That turbo is all the bolt on you need.
|
|
|
Post by ndrprssr2001 on Sept 15, 2014 17:58:05 GMT -5
Looks about the same to me. About half to three quarter of an inch over and every bit as deep or a little deeper then the stock location.Really sits in there quite nicely once the fitting is done. Pretty happy so far.
|
|
|
Post by ndrprssr2001 on Sept 15, 2014 18:08:51 GMT -5
Of course this is all just mock up. I plan on bolting engine, converter and transmission together before they for in for good.
|
|
|
Post by uzahiwuyazebe on Nov 14, 2019 16:24:24 GMT -5
|
|
|
Post by buy cialis usa on Dec 3, 2021 5:30:43 GMT -5
|
|
|
Post by buy cialis usa on Dec 3, 2021 5:31:58 GMT -5
|
|
|
Post by buy cialis usa on Dec 3, 2021 5:35:18 GMT -5
|
|